Cisco ASR 9000 Series Command Reference Guide

Examples
The following example shows how to enter channel group configuration mode for channel group number 5
and change the speed of the underlying DS0s in the channel group to 56 kbps:
RP/0/RSP0/CPU0:router(config)# controller t1 0/6/0/0/10
RP/0/RSP0/CPU0:router(config-t1)# channel-group 5
RP/0/RSP0/CPU0:router(config-t1-channel_group)# speed 56
The following example shows how to associate DS0 time slots 1, 6, 8, 9, and 10 to channel group 5:
RP/0/RSP0/CPU0:router(config)# controller t1 0/6/0/0/10
RP/0/RSP0/CPU0:router(config-t1)# channel-group 5
RP/0/RSP0/CPU0:router(config-t1-channel_group)# timeslots 1:6:8-10
Related Commands
DescriptionCommand
Enables a BERT pattern on a T3/E3 or T1/E1 line or an individual
channel group.
bert pattern, on page 947
Selects the frame type for an E1 data line.framing (E1), on page 1002
Selects the frame type for a T1 data line.framing (T1), on page 1006
Sets the mode of the T3/E3 or T1/E1 controller.mode, on page 1029
Specifies the speed of the underlying DS0s in a channel group.speed (DS0), on page 1067
Associates one or more DS0 time slots to a channel group and create
an associated serial subinterface.
timeslots, on page 1069
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
958
T3, E3, T1, E1 Controller Commands on the Cisco ASR 9000 Series Router
channel-group

Cisco ASR 9000 Series Specifications

General

Series	ASR 9000
Category	Network Router
Modular Design	Yes
Redundancy	Yes (Hardware and Software)
Operating System	Cisco IOS XR
Interfaces/Ports	10G, 40G, 100G, 400G Ethernet
Expansion Slots	Varies by model
Routing Protocol	BGP, OSPF, IS-IS, EIGRP
Management	CLI, SNMP, NETCONF
Power Supply	Redundant
Port Density	Varies by model
Power Supply Options	AC, DC
Memory	Varies by model
Storage	Varies by model
Dimensions	Varies by model
Weight	Varies by model