Enterasys SecureStack C2 C2G170-24

Clearing and Closing the CLI
SecureStack C2 Configuration Guide 3-47
Clearing and Closing the CLI
Purpose
TocleartheCLIscreenortocloseyourCLIsession.
Commands
cls (clear screen)
UsethiscommandtoclearthescreenforthecurrentCLIsession.
Syntax
cls
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐only.
Example
ThisexampleshowshowtocleartheCLIscreen:
C2(su)->cls
exit
UseeitherofthesecommandstoleaveaCLIsession.
Syntax
exit
Parameters
None.
Defaults
None.
For information about... Refer to page...
cls 3-47
exit 3-47