Enterasys SecureStack C2 C2G170-24 - Clear Nodealias Config

clear nodealias config
SecureStack C2 Configuration Guide 14-37
Itʹsimportanttomakesurethatinter‐switchlinksare notlearningnode/aliasinformation,asit
wouldslowdownsearchesbytheNetSightCompassandASMtoolsandgiveinaccurateresults.
Example
Thisexampleshowshowtodisablethenodealiasagentonge.1.3:
C2(su)->set nodealias disable ge.1.3
clear nodealias config
Usethiscommandtoresetnodealiasstatetoenabledandclearthemaximumentriesvalue.
Syntax
clear nodealias config port-string
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
Thisexampleshowshowtoresetthenodealiasconfigurationonge.1.3:
C2(su)->clear nodealias config ge.1.3
port‐string Specifiestheport(s)onwhichtoresetthenodealiasconfiguration.