Enterasys SecureStack C2 C2G170-24

set igmpsnooping maxresponse
SecureStack C2 Configuration Guide 13-5
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Usage
TheIGMPgroupmembershipintervaltimesetsthefrequencyofhost‐queryframetransmissions
andmustbegreaterthantheIGMPmaximumresponsetimeasdescribedin“setigmpsnooping
maxresponse”onpage 13‐5.
Example
ThisexampleshowshowtosettheIGMPgroupmembershipintervalto250seconds:
C2(su)->set igmpsnooping groupmembershipinterval 250
set igmpsnooping maxresponse
UsethiscommandtoconfiguretheIGMPquerymaximumresponsetimeforthesystem.
Syntax
set igmpsnooping maxresponse time
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Usage
ThisvaluemustbelessthantheIGMPmaximum responsetimedescribedin“setigmpsnooping
groupmembershipinterval”onpage 13‐4.
time SpecifiestheIGMPgroupmembershipinterval.Validvaluesare2‐3600
seconds.
Thisvalueworkstogetherwiththesetigmpsnoopingmaxresponsetime
commandtoremoveportsfromanIGMPgroupandmust
begreaterthan
themaxresponsetimevalue.
time SpecifiestheIGMPmaximumqueryresponsetime.Validvaluesare100‐
255seconds.Thedefaultvalueis100seconds.
Thisvalueworkstogetherwiththesetigmpsnooping
groupmembershipintervalcommandtoremoveportsfromanIGMPgroup
andmustbelesserthanthegroupmembershipintervalvalue.