Enterasys SecureStack C2 C2G170-24

show system
SecureStack C2 Configuration Guide 3-13
Mode
Switchcommand,read‐write.
Example
ThisexampleshowshowtosetthemethodusedtoacquireanetworkIPaddresstoDHCP.
C2(su)->set ip protocol dhcp
show system
Usethiscommandtodisplaysysteminformation,includingcontactinformation,powerandfan
traystatusanduptime.
Syntax
show system
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐only.
Example
Thisexampleshowshowtodisplaysysteminformation:
C2(su)->show system
System contact:
System location:
System name:
Switch 1
--------
PS1-Status PS2-Status
---------- ----------
Ok Not Installed and/or Not Operating
Fan1-Status Fan2-Status
----------- -----------
Ok Ok
Temp-Alarm
-----------
off
Thermal Threshold: 58%
Temp alarm max threshold: 100%
Temp alarm trap: disabled
Temp alarm syslog: disabled
Uptime d,h:m:s Logout
-------------- -------
0,20:36:49 0 min