Enterasys SecureStack C2 C2G170-24 - Clear Port Priority

clear port priority
SecureStack C2 Configuration Guide 12-3
Syntax
set port priority port-string priority
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Usage
Thesetportprioritycommandwillnotchangethe802.1pprioritytagontaggedtrafficwitha
defaultprioritytag.Thecommandonlyhasaneffectonhowuntaggedtrafficwillbeprioritized
asitpassesinternallythroughthedevice.
Example
Thisexampleshowshowtosetadefaultpriorityof6onge.1.3.Framesreceivedbythisport
withoutpriorityinformationintheirframeheaderaresettothedefaultsettingof6:
C2(su)->set port priority ge.1.3 6
clear port priority
UsethiscommandtoresetthecurrentCoSportprioritysettingto0.Thiswillcauseallframes
receivedwithoutapriority valueinitsheadertobesettopriority0.
Syntax
clear port priority port-string
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
port‐string Specifiestheportforwhichtosetpriority.Foradetaileddescriptionof
possibleport‐stringvalues,referto“PortStringSyntaxUsedintheCLI”on
page 7‐2.
priority Specifiesavalueof0to7tosettheCoSpriorityfortheport
enteredinthe
port‐string.Priorityvalueof0isthelowestpriority.
port‐string Specifiestheportforwhichtoclearpriority.Foradetaileddescriptionof
possibleport‐stringvalues,referto“PortStringSyntaxUsedintheCLI”on
page 7‐2.