Enterasys SecureStack C2 C2G170-24

Configuring SNMP Users, Groups, and Communities
8-8 SNMP Configuration
Configuring SNMP Users, Groups, and Communities
Purpose
ToreviewandconfigureSNMPusers,groups,andv1andv2communities.Thesearedefinedas
follows:
•User—ApersonregisteredinSNMPv3toaccessSNMPmanagement.
•Group—Acollectionofuserswhosharethesa meSNMPaccessprivileges.
• Community—AnameusedtoauthenticateSNMPv1andv2users.
Commands
show snmp user
UsethiscommandtodisplayinformationaboutSNMPusers.Thesearepeopleregisteredto
accessSNMPmanagement.
Syntax
show snmp user [list] | [user] | [remote remote] [volatile | nonvolatile | read-
only]
Parameters
Defaults
Iflistisnotspecified,detailedSNMPinformationwillbedisplayed.
For information about... Refer to page...
show snmp user 8-8
set snmp user 8-9
clear snmp user 8-10
show snmp group 8-11
set snmp group 8-12
clear snmp group 8-12
show snmp community 8-13
set snmp community 8-14
clear snmp community 8-14
list (Optional)DisplaysalistofregisteredSNMPusernames.
user (Optional)Displaysinformationaboutaspecificuser.
remoteremote (Optional)DisplaysinformationaboutusersonaspecificremoteSNMP
engine.
volatile|nonvolatile
|read‐only
(Optional)Displaysuserinformationforaspecifiedstoragetype.