Enterasys SecureStack C2 C2G170-24

traceroute ipv6
SecureStack C2 Configuration Guide 21-9
traceroute ipv6
Usethiscommandtodiscovertheroutesthatpacketsactually takewhentravelingtotheir
destinationthroughthenetworkonahop‐by‐hopbasis.
Syntax
traceroute ipv6 ipv6-addr
Parameters
Defaults
None.
Mode
Switchmode,read‐write.
Usage
Thiscommandisalsoavailableinroutermode.
Example
Thisexampleshowshowtousetraceroutetodisplayaroundtrippathtohost
2001:0db8:1234:5555
C2(su)->router#traceroute ipv6 2001:0db8:1234:5555::1
Traceroute to 2001:0db8:1234:5555, 30 hops max, 40 byte packets
1 2001:0db8:1234:5555 1.000000e+00 ms 1.000000e+00 ms 1.000000e+00 ms
ipv6‐addr SpecifiesahosttowhichtherouteofanIPv6packetwillbetraced.Enterthe
addressintheformdocumentedinRFC4291,withtheaddressspecifiedin
hexadecimalusing16‐bitvaluesbetweencolons.