Enterasys SecureStack C2 C2G170-24

Setting Speed and Duplex Mode
7-10 Port Configuration
Setting Speed and Duplex Mode
Purpose
ToreviewandsettheoperationalspeedinMbpsandthedefaultduplexmode:Half,forhalf
duplex,orFull,forfullduplexforoneormoreports.
Commands
show port speed
Usethiscommandtodisplaythedefaultspeedsettingononeormoreports.
Syntax
show port speed [port-string]
Parameters
Defaults
Ifport‐stringisnotspecified,defaultspeedsettingsforallportswilldisplay.
Mode
Switchcommand,read‐only.
Example
Thisexampleshowshowtodisplaythedefaultspeedsettingfor1‐GigabitEthernetport14in
slot 3:
C2(su)->show port speed ge.3.14
default speed is 10 on port ge.3.14.
Note: These settings only take effect on ports that have auto-negotiation disabled.
For information about... Refer to page...
show port speed 7-10
set port speed 7-11
show port duplex 7-11
set port duplex 7-15
port‐string (Optional)Displaysdefaultspeedsetting(s)forspecificport(s).Fora
detaileddescriptionofpossibleport‐stringvalues,referto“ PortString
SyntaxUsedintheCLI”onpage7‐2.