Enterasys SecureStack C2 C2G170-24 - Set Sntp Poll-Interval; Clear Sntp Poll-Interval

set sntp poll-interval
SecureStack C2 Configuration Guide 14-31
Mode
Switchcommand,read‐write.
Example
ThisexampleshowshowtoremovetheserveratIPaddress10.21.1.100 fromtheSNTPserverlist:
C2(su)->clear sntp server 10.21.1.100
set sntp poll-interval
UsethiscommandtosetthepollintervalbetweenSNTPunicastrequests.
Syntax
set sntp poll-interval interval
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
ThisexampleshowshowtosettheSNTPpollintervalto30seconds:
C2(su)->set sntp poll-interval 30
clear sntp poll-interval
UsethiscommandtoclearthepollintervalbetweenunicastSNTPrequests.
Syntax
clear sntp poll-interval
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐write.
interval Specifiesthepollintervalinseconds.Validvaluesare16to16284.