Enterasys SecureStack C2 C2G170-24 - Set Igmpsnooping Remove-Static; Show Igmpsnooping Static

set igmpsnooping remove-static
SecureStack C2 Configuration Guide 13-7
Ifmodifyisnotspecified,anewentryiscreated.
Mode
Switchcommand,read‐write.
Usage
UsethiscommandtocreateandconfigureLayer2IGMPentries.
Example
ThisexamplecreatesanIGMPentryforthemulticastgroupwithIPaddressof233.11.22.33
configuredonVLAN20configuredwiththeportge.1.1.
C2(su)->set igmpsnooping add-static 233.11.22.33 20 ge.1.1
set igmpsnooping remove-static
ThiscommanddeletesastaticIGMPentryorremovesoneormorenewportsfromanexisting
entry.
Syntax
set igmpsnooping remove-static group vlan-list [modify] [port-string]
Parameters
Defaults
Ifnoportsarespecified,allportsareremovedfromtheentry.
Mode
Switchcommand,read‐write.
Example
Thisexampleremovesportge.1.1fromtheentryforthemulticastgroupwithIPaddressof
233.11.22.33configuredonVLAN20.
C2(su)->set igmpsnooping remove-static 233.11.22.33 20 ge.1.1
show igmpsnooping static
ThiscommanddisplaysstaticIGMPportsforoneormoreVLANsorIGMPgroups.
Syntax
show igmpsnooping static vlan-list [group group]
group SpecifiesthemulticastgroupIPaddressoftheentry.
vlan‐list SpecifiestheVLANsonwhichtheentryisconfigured.
modify (Optional)Removesthespecifiedportorportsfromanexistingentry.
port‐string (Optional)Specifiestheportorportstoremovefromtheentry.