Enterasys SecureStack C2 C2G170-24

Configuring Spanning Tree Port Parameters
SecureStack C2 Configuration Guide 9-33
Configuring Spanning Tree Port Parameters
Purpose
TodisplayandsetSpanningTreeportparameters.
Commands
set spantree portadmin
UsethiscommandtodisableorenabletheSpanningTreealgorithmononeormoreports.
Syntax
set spantree portadmin port-string {disable | enable}
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
For information about... Refer to page...
set spantree portadmin 9-33
clear spantree portadmin 9-34
show spantree portadmin 9-34
show spantree portpri 9-35
set spantree portpri 9-35
clear spantree portpri 9-36
show spantree adminpathcost 9-37
set spantree adminpathcost 9-37
clear spantree adminpathcost 9-38
show spantree adminedge 9-38
set spantree adminedge 9-38
clear spantree adminedge 9-39
port‐string Specifiestheport(s)forwhichtoenableordisableSpanningTree.Fora
detaileddescriptionofpossibleport‐stringvalues,referto“ PortString
SyntaxUsedintheCLI”onpage 7‐2.
disable|ena ble DisablesorenablesSpanningTree.