Enterasys SecureStack C2 C2G170-24

clear dhcp pool option
SecureStack C2 Configuration Guide 16-29
clear dhcp pool option
UsethiscommandtoremoveaDHCPoptionfromthe addresspoolbeingconfigured.
Syntax
clear dhcp pool poolname option code
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
Thisexampleremovesoption19fromaddresspool“auto1.”
C2(rw)->clear dhcp pool auto1 option 19
show dhcp pool configuration
Usethiscommandtodisplayconfigurationinformationforoneoralladdresspools.
Syntax
show dhcp pool configuration {poolname | all}
Parameters
Defaults
None.
Mode
Read‐only.
Example
Thisexampledisplaysconfigurationinformationforalladdresspools.
C2(rw)->show dhcp pool configuration all
Pool: Atg_Pool
Pool Type Dynamic
poolname Specifiesthenameoftheaddresspool.Poolnamesmaybeupto31
charactersinlength.
code SpecifiestheDHCPoptioncode,asdefinedinRFC2132.Valuecanrange
from1to254.
poolname Specifiesthenameoftheaddresspool.Poolnamesmaybeupto31
charactersinlength.