Enterasys SecureStack C2 C2G170-24 - Installing Previously-Configured Systems in a Stack; Adding a New Unit to an Existing Stack; Creating a Virtual Switch Configuration

show port protected
SecureStack C2 Configuration Guide 7-53
Example
Thisexampleshowshowtoassignportsge.1.1throughge.1.3toprotectedportgroup1:
C2(rw)->set port protected ge.1.1-3 1
show port protected
Usethiscommandtodisplayinformationabouttheportsconfiguredforprotectedmode.
Syntax
show port protected [port-string] | [group-id]
Parameters
Defaults
Ifnoparametersareentered,informationaboutallprotectedportsisdisplayed.
Mode
Read‐only.
Example
Thisexampleshowshowtodisplayinformationaboutallprotectedports:
C2(ro)->show port protected
Group id Port
----------------------
1 ge.1.1
1 ge.1.2
1 ge.1.3
clear port protected
Usethiscommandtoremoveaportorgroupfromprotectedmode.
Syntax
clear port protected [port-string] | [group-id]
Parameters
Defaults
Ifnoparametersareentered,allprotectedportsandgroupsarecleared.
port‐string (Optional)Specifiestheportorportsforwhichtodisplayinformation.
group‐id (Optional)Specifiestheidofthegroupforwhichtodisplayinformation.
Idcanrangefrom0to2.
port‐string (Optional)Specifiestheportorportstoremovefromprotectedmode.
group‐id (Optional)Specifiestheidofthegrouptoremovefromprotectedmode.
Idcanrangefrom0to2.