To Next Page

To Previous Page

History Group Commands

15-6 RMON Configuration

History Group Commands

Purpose

Todisplay,configure,andclearRMONhistorypropertiesandstatistics.

Commands

show rmon history

UsethiscommandtodisplayRMONhistorypropertiesandstatistics.TheRMONhistorygroup

recordsperiodicstatisticalsamplesfromanetwork.

Syntax

show rmon history [port-string]

Parameters

Defaults

Ifport‐stringisnotspecified,informationaboutallRMONhistoryentrieswillbedisplayed.

Mode

Switchcommand,read‐only.

Example

ThisexampleshowshowtodisplayRMONhistoryentriesforGigabitEthernetport1inswitch1.

Acontrolentrydisplaysfirst,followedbyactualentriescorrespondingtothecontrolentry.Inthis

case,thedefaultsettingsforentryowner,samplinginterval,andmaximumnumberofentries.

(buckets)havenotbeen

changedfromtheirdefaultvalues.Foradescriptionofthetypesof

statisticsshown,refertoTable 15‐2.

C2(su)->show rmon history ge.1.1

Port: ge.1.1

-------------------------------------

Index 1

Owner = monitor

Status = valid

Data Source = ifIndex.1

Interval = 30

Buckets Requested = 50

Buckets Granted = 10

For information about... Refer to page...

show rmon history 15-6

set rmon history 15-7

clear rmon history 15-7

port‐string (Optional)DisplaysRMONhistoryentriesforspecificport(s).

Enterasys SecureStack C2 C2G170-24 User Manual

Other manuals for Enterasys SecureStack C2 C2G170-24