Enterasys SecureStack C2 C2G170-24

show support
SecureStack C2 Configuration Guide 3-53
show support
Usethiscommandtodisplayswitchinformationfortroubleshooting.
Syntax
show support
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐only.
Usage
Thiscommandinitiatesanumberofshowcommandstoeasilygatherbasicinformationfroman
installeddevice.Tousethiscommand,setyourconsoletocapturetheoutputtoafilefirst,before
executingthecommand,sincetheoutputisextensive.
Outputfromthefollowingcommandsisgatheredbythiscommand:
• show
version
• showloggingbuffer
• showportstatus
• showsystemutilizationprocess
• showsystemutilizationstorage
• showconfig
Example
Thereisnodisplayexamplebecausetheoutputofthiscommandisquite lengthy.