Enterasys SecureStack C2 C2G170-24

show ip pimsm rphash
SecureStack C2 Configuration Guide 20-57
Defaults
None.
Mode
Anyroutermode.
Examples
ThisexampleshowshowtodisplaytheRPsetforaspecificgroupaddress.
C2(su)->router> show ip pimsm rp 224.0.0.0 240.0.0.0
RP SET TABLE
Group
Address Group Mask Address Hold Time Expiry Time Component C-RP Priority
(hh:mm:ss) (hh:mm:ss)
--------- ---------- ----------- ---------- ----------- --------- -----------
224.0.0.0 240.0.0.0 192.168.30.2 00:02:15 00:02:30 1 0
Table 20‐12providesanexplanationofthecommandoutput.
ThisexampleshowshowtodisplaythecandidateRPsforeachgroupaddress.
C2(su)->router> show ip pimsm rp candidate
CANDIDATE RP TABLE
Group Address Group Mask Address
--------------- --------------- ---------------
224.0.0.0 240.0.0.0 192.168.30.2
show ip pimsm rphash
DisplaystheRendezvousPointrouterthatwillbeselectedfromthesetofactiveRProuters.The
RProuter,forthegroup,isselectedbyusingthehashalgorithmdefinedinRFC2362.
Syntax
show ip pimsm rphash group-address
Table 20-12 show ip pimsm rp Output Details
Output Field What it displays
Group Address The address of the group for which the RP set is displayed.
Group Mask The mask of the group address.
Address The IP address of the RP.
Hold Time The hold time of the RP.
Expiry Time The minimum time remaining before the RP will be declared down.
Component A number which uniquely identifies the component. Each protocol instance
connected to a separate domain should have a different index value.
C-RP Priority The candidate-RP priority of the RP.