Enterasys SecureStack C2 C2G170-24

Configuring Port Web Authentication (PWA)
SecureStack C2 Configuration Guide 23-61
Configuring Port Web Authentication (PWA)
About PWA
PWAprovidesawayofauthenticatingusersbeforeallowinggeneralaccesstothenetwork
TologonusingPWA,theusermakesarequestthroughawebbrowserforthePWAwebpageoris
automaticallyredirectedtothisloginpageafterrequestingaURLinabrowser.
Dependinguponthe
authenticatedstat eoftheuser,aloginpageoralogoutpagewilldisplay.
Whenausersubmitsusernameandpassword,theswitchthenauthenticatestheuserviaa
preconfiguredRADIUSserver.Iftheloginissuccessful,thentheuserwillbegrantedfullnetwork
accessaccordingtotheuser’s
policyconfigurationontheswitch.
Purpose
Toreview,enable,disable,andconfigurePortWebAuthentication(PWA).
Commands
Note: One user per PWA-configured port can be authenticated on SecureStack C2 devices.
PWA authentication does not support RFC-3580 VLAN authorization.
For information about... Refer to page...
show pwa 23-62
set pwa 23-63
show pwa banner 23-64
set pwa banner 23-64
clear pwa banner 23-65
set pwa displaylogo 23-65
set pwa ipaddress 23-66
set pwa protocol 23-66
set pwa guestname 23-67
clear pwa guestname 23-67
set pwa guestpassword 23-68
set pwa gueststatus 23-68
set pwa initialize 23-69
set pwa quietperiod 23-69
set pwa maxrequest 23-70
set pwa portcontrol 23-70
show pwa session 23-71
set pwa enhancedmode 23-72