Enterasys SecureStack C2 C2G170-24 - Clear Port Mirroring

clear port mirroring
7-36 Port Configuration
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Usage
NotethatLAGportsandtheirunderlyingphysicalports,asdescribedin“LinkAggregation
ControlProtocol(LACP)”onpage7‐38,cannotbemirrored.
Example
Thisexampleshowshowtocreateandenableportmirroringwithge.1.4asthesourceport,and
ge.1.11asthetargetport:
C2(su)->set port mirroring create ge.1.4 ge.1.11
C2(su)->set port mirroring enable ge.1.4 ge.1.11
clear port mirroring
Usethiscommandtoclearaportmirroringrelationship.
Syntax
clear port mirroring source destination
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
create|disable|
enable
Creates,disablesorenablesmirroringsettingsonthespecifiedports.
source Specifiesthesourceportdesignation.Thisistheportonwhichthetraffic
willbemonitored.Foradetaileddescriptionofpossibleport‐stringvalues,
referto“PortStringSyntaxUsedin
theCLI”onpage7‐2.
destination Specifiesthetargetportdesignat ion. Thisistheportthatwillduplicateor
“mirror”allthetrafficonthemonitoredport.Onlyonedestinationport
canbeconfiguredperstack,ifapplicable.
Foradetaileddescriptionofpossibleport‐stringvalues,referto“Port

StringSyntaxUsedintheCLI”onpage7‐2.
source Specifiesthesourceportofthemirroringconfigurationtobecleared.For
adetaileddescriptionofpossibleport‐stringvalues,refer to“PortString
SyntaxUsedintheCLI”onpage7‐2.
destination Specifiesthetargetportofthemirroringconfigurationtobecleared.