Enterasys SecureStack C2 C2G170-24

clear arpinspection filter
SecureStack C2 Configuration Guide 17-29
clear arpinspection filter
UsethiscommandtoremoveanARPACLfromaVLANorfromtheswitch,ortoremovea
permitrulefromanexistingACL,ortochangethestatusofstaticmappingtodisabled.
Syntax
clear arpinspection filter name [permit ip host sender-ipaddr mac host
sender-macaddr] | [vlan vlan-range [static]
Parameters
Defaults
Ifonlythenameisspecified,theACLisdeletedfromtheswitch.
Mode
Switchcommand,read‐write.
Usage
Youcanusethiscommandto:
•RemoveaconfiguredARPACLfromtheswitch,or
•RemoveapermitrulefromaconfiguredARPACL,or
•RemovetheassociationofanARPACLwitha VLANorVLANs, or
•DisablestaticmappingofanARPACLassociatedwithaVLANorVLANs.
Usethe
setarpinspectionfiltercommandtocreateandassignanARPACL.
Usetheshowarpinspectionaccess‐listcommandtodisplaycurrentlyconfiguredARPACLs.
Examples
ThisexampleremovesapermitrulefromtheARPACLnamedstaticARP.
C2(su)->clear arpinspection filter staticARP permit ip host 192.168.1.10 mac host
00:01:22:33:44:55
ThisexampledisablesstaticmappingoftheARPACLnamedstaticARPthatisassociatedwith
VLAN5.
C2(su)->clear arpinspection filter staticARP vlan 5 static
name Specifiesthe nameoftheARPACL.
permit (Optional)Specifiesthatapermitruleisbeingdeleted.
iphostsender‐ipaddr SpecifiestheIPaddressintherulebeingdeleted.
machost
sender‐macaddr
SpecifiestheMACaddressintherulebeingdeleted.
vlanvlan‐range (Optional)SpecifiestheVLANorVLANstowhich
thiscommand
shouldapply.RemovetheACLfromtheVLAN,ifstaticisnotspecified
also.
static (Optional)SpecifiesthatstaticmappingshouldbedisabledforthisARP
ACLforthespecifiedVLANorVLANs.