Enterasys SecureStack C2 C2G170-24 - Set Ssl; Gathering Technical Support Information; Command; Purpose

set ssl
3-52 Basic Configuration
Example
ThisexampleshowshowtodisplaySSLstatus:
C2(rw)->show ssl
SSL status: Enabled
set ssl
UsethiscommandtoenableordisabletheuseofWebViewoverSSLport443.Bydefault,SSLis
disabledontheswitch.Thiscommandcanalsobeusedtoreinitializethehostkey thatisusedfor
encryption.
Syntax
set ssl {enabled | disabled | reinitialize | hostkey reinitialize}
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
ThisexampleshowshowtoenableSSL:
C2(rw)->set ssl enabled
Gathering Technical Support Information
Purpose
Togathercommontechnicalsupportinformation.
Command
enabled|disabled EnableordisabletheabilitytouseWebViewoverSSL.
reinitialize StopsandthenrestartstheSSLprocess.
hostkeyreinitialize StopsSSL,regeneratesnewkeys,andthenrestartsSSL.
For information about... Refer to page...
show support 3-53