Enterasys SecureStack C2 C2G170-24

set password
SecureStack C2 Configuration Guide 3-5
Parameters
Defaults
None.
Mode
Switchcommand,superuser.
Example
Thisexampleshowshowtoremovethe“netops”useraccount:
C2(su)->clear system login netops
set password
UsethiscommandtochangesystemdefaultpasswordsortosetanewloginpasswordontheCLI.
Syntax
set password [username]
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Switchcommand,super‐user.
Usage
Read‐Writeuserscanchangetheirownpasswords.
SuperUsers(Admin)canchangeanypasswordonthesystem.
Ifyouforgetthepasswordfortheadminuseraccount,youcan resetthepasswordtothedefault
passwordvaluebypressingthepasswordresetbuttonontheswitch.
username Specifiestheloginname
oftheaccounttobecleared.
Note: The default admin (su) account cannot be deleted.
username (Onlyavailabletouserswithsuper‐useraccess.)Specifiesasystemdefault
orauser‐configuredloginaccountname.Bydefault,theSecureStackC2
switchprovidesthefollowingaccountnames:
roforRead‐Onlyaccess.
rwforRead‐Writeaccess.
adminforSuperUseraccess.(ThisaccesslevelallowsRead ‐Write
access
toallmodifiableparameters,includinguseraccounts.)