Enterasys SecureStack C2 C2G170-24

ip ospf cost
SecureStack C2 Configuration Guide 20-15
Mode
Interfaceconfiguration:C2(su)‐>router(Config‐if(Vlan1))#
Example
ThisexampleshowshowtoconfiguretheVLAN 1interfaceasarea0.0.0.31 :
C2(su)->router(Config)#interface vlan 1
C2(su)->router(Config-if(Vlan 1))#ip ospf areaid 0.0.0.31
ip ospf cost
UsethiscommandtosetthecostofsendinganOSPFpacketonanint erface.Thenoformofthis
commandresetstheOSPFcosttothedefaultof10.
Syntax
ip ospf cost cost
no ip ospf cost
Parameters
Defaults
None.
Mode
Interfaceconfiguration:C2(su)‐>router(Config‐if(Vlan1))#
Usage
EachrouterinterfacethatparticipatesinOSPFroutingisassignedadefaultcost.Thiscommand
overwritesthedefaultof10.
Example
ThisexampleshowshowtosettheOSPFcostto20fortheVLAN1interface:
C2(su)->router(Config)#interface vlan 1
C2(su)->router(Config-if(Vlan 1))#ip ospf cost 20
ip ospf priority
UsethiscommandtosettheOSPFpriorityvalueforrouterinterfaces.Thenoformofthis
commandresetsthevaluetothedefaultof1.
Syntax
ip ospf priority number
no ip ospf priority
cost Specifiesthecostofsendingapacket.Validvaluesrangefrom1to65 535.