Enterasys SecureStack C2 C2G170-24

ip irdp holdtime
SecureStack C2 Configuration Guide 20-39
Example
ThisexampleshowshowtosettheminimumIRDPadvertisementintervalto500secondsonthe
VLAN1interface:
C2(su)->router(Config)#interface vlan 1
C2(su)->router(Config-if(Vlan 1))#ip irdp minadvertinterval 500
ip irdp holdtime
UsethiscommandtosetthelengthoftimeinsecondsIRDPadvertisementsareheldvalid.Theno
formofthiscommandresetstheholdtimetothedefaultvalueofthreetimesthe
maxadvertintervalvalue,whichisequalto1800seconds.
Syntax
ip irdp holdtime holdtime
no irdp holdtime
Parameters
Defaults
None.
Mode
Interfaceconfiguration:C2(su)‐>router(Config‐if(Vlan1))#
Example
ThisexampleshowshowtosettheIRDPholdtimeto4000secondsontheVLAN1interface:
C2(su)->router(Config)#interface vlan 1
C2(su)->router(Config-if(Vlan 1))#ip irdp holdtime 4000
ip irdp preference
UsethiscommandtosettheIRDPpreferencevalueforaninterface.ThisvalueisusedbyIRDPto
determinetheinterface’sselectionasadefaultgatewayaddress.Thenoformofthiscommand
resetstheinterface’sIRDPpreferencevaluetothedefaultof0.
Syntax
ip irdp preference preference
no irdp preference
Parameters
holdtime Specifiestheholdtimeinseconds.Validvaluesare0to
9000.
preference Specifiesthevaluetoindicatetheinterface’suseasadefaultrouter
address.Validvaluesare‐214748 3648to2147483647.
Theminimumvalueindicatesthattheaddress,eventhoughitmaybe
advertised,isnottobeusedbyneighboringhostsasadefaultrouter
address.