To Next Page

To Previous Page

set switch movemanagement

SecureStack C2 Configuration Guide 2-11

Mode

Switchcommand,read‐write.

Example

Thisexampleshowshowtoassignthename“FirstUnit” toswitchunit1inthestack:

C2(su)->set switch description 1 FirstUnit

set switch movemanagement

Usethiscommandtomovemanagementsw itchfunctionalityfromoneswitchtoanother.

Syntax

set switch movemanagement fromunit tounit

Parameters

Defaults

None.

Mode

Switchcommand,read‐write.

Example

Thisexampleshowshowtomovemanagementfunctionalityfromswitch1toswitch2:

C2(su)->set switch movemenagement 1 2

Moving stack management will unconfigure entire stack including all interfaces.

Are you sure you want to move stack management? (y/n) y

set switch member

Usethiscommandtoaddavirtualmembertoastack.Thisallowsyoutopreconfigureaswitch

beforethephysicaldeviceisactuallyaddedtothestack.

Syntax

set switch member unit switch-id

Parameters

Defaults

None.

fromunit Specifiestheunitnumberofthecurrentmanagementswitch.

tounit Specifiestheunitnumberofthenewly‐designatedmanagementswitch.

unit Specifiesaunitnumberfortheswitch.

switch‐id SpecifiesaswitchID(SID)fortheswitch.SIDscanbedisplayedwiththe

showswitchswitchtypecommand.

Enterasys SecureStack C2 C2G170-24 User Manual

Other manuals for Enterasys SecureStack C2 C2G170-24