Enterasys SecureStack C2 C2G170-24

Commands
SecureStack C2 Configuration Guide 22-3
Commands
ipv6 proxy-routing
UsethiscommandtoenableordisableIPv6proxyroutingonamixedC2/C3stack.
Syntax
ipv6 proxy-routing
no ipv6 proxy-routing
Parameters
None.
Defaults
IPv6proxyroutingisdisabledbydefault.
Mode
Routerglobalconfiguration:C2(su)‐>router(Config)#
Usage
IPv6proxyroutingisdisabledbydefault.ItmustbeenabledwiththiscommandbeforetheC2
switchesinthestackwillstartredirectingroutedIPv6/tunnelingpacketstotheC3proxyserver.
UsesthenoformofthiscommandtodisableIPv6proxyrouting.
Example
ThisexampleenablesIPv6proxyrouting.
c2(su)->router
c2(su)->router>enable
c2(su)->router#config
Enter configuration commands:
c2(su)->router(Config)#ipv6 proxy-routing
show ipv6 proxy-routing
UsethiscommandtodisplaythestatusofIPv6proxyrouting.
Syntax
show ipv6 proxy-routing
Parameters
None.
For information about... Refer to page...
ipv6 proxy-routing 22-3
show ipv6 proxy-routing 22-3