Enterasys SecureStack C2 C2G170-24

show arpinspection ports
SecureStack C2 Configuration Guide 17-25
ARP access list staticARP
permit ip host 192.168.1.10 mac host 00:01:22:33:44:55
permit ip host 192.168.1.20 mac host 00:0A:11:22:33:66
show arpinspection ports
UsethiscommandtodisplaytheARPconfigurationofoneormoreports.
Syntax
show arpinspection ports [port-string]
Parameters
Defaults
Ifaport‐stringisnotspecified,informationaboutallDAI‐enableduntrustedportsisdisplayed.
Mode
Switchcommand,read‐write.
Example
ThisexampledisplaystheARPconfigurationoflag.0.1.
C2(su)->show arpinspection ports lag.0.1
Interface Trust State Rate Limit Burst Interval
(pps) (seconds)
---------- ------------- ------------- ---------------
lag.0.1 No 15 1
show arpinspection vlan
UsethiscommandtodisplaytheARPconfigurationofoneormoreVLANs.
Syntax
show arpinspection vlan vlan-range
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
port‐string (Optional)SpecifiestheportorportsforwhichtodisplayARP
configurationinformation.
vlan‐range SpecifiestheVLANsforwhichtodisplayconfigurationinformation.