Enterasys SecureStack C2 C2G170-24 - Show Eapol

show eapol
SecureStack C2 Configuration Guide 23-17
Thisexampleshowshowtoresetthe802.1Xquietperiodto60secondsonportsfe.1.1‐3:
C2(su)->clear dot1x auth-config quietperiod fe.1.1-3
show eapol
UsethiscommandtodisplayEAPOLstatusorsettingsforoneormoreports.
Syntax
show eapol [port-string]
Parameters
Defaults
Ifport‐stringisnotspecified,onlyEAPOLenablestatuswillbedisplayed.
Mode
Switchcommand,read‐only.
Example
ThisexampleshowshowtodisplayEAPOLstatusforportsfe.1.1‐3:
C2(su)->show eapol fe.1.1-3
EAPOL is disabled.
Port Authentication State Authentication Mode
-------- -------------------- --------------------
fe.1.1 Initialize Auto
fe.1.2 Initialize Auto
fe.1.3 Initialize Auto
Table 23‐2providesanexplanationofthecommandoutput.For detailsonusingtheseteapol
commandtoenabletheprotocolandassignanauthenticationmode,referto“seteapol”on
page 23‐19.
port‐string (Optional)DisplaysEAPOLstatusforspecificport(s).Foradetailed
descriptionofpossibleport‐stringvalues,
referto“PortStringSyntaxUsed
intheCLI”onpage 7‐2.