Enterasys SecureStack C2 C2G170-24 - Resetting the Switch; Commands; Purpose; Reset

Resetting the Switch
3-48 Basic Configuration
Mode
Switchcommand,read‐only.
Usage
Bydefault,switchtimeoutoccursafter15minutesofuserinactivity,automaticallyclosingyour
CLIsession.Usethesetlogoutcommand(page3‐29)tochangethisdefault.
Example
ThisexampleshowshowtoexitaCLIsession:
C2(su)->exit
Resetting the Switch
Purpose
Toresetoneormoreswitches,andtocleartheuser‐definedconfigurationparameters.
Commands
reset
Usethiscommandtoresettheswitchwithoutlosinganyuser‐definedconfigurationsettings.
Syntax
reset [unit]
Parameters
Defaults
IfnounitIDisspecified,theentiresystemwillbereset.
Mode
Switchcommand,read‐write.
Usage
ASecureStackC2switchcanalsoberesetwiththeRESETbuttonlocatedonitsfrontpanel.For
informationonhowtodothis,refertotheSecureStackC2InstallationGuideshippedwithyour
switch.
For information about... Refer to page...
reset 3-48
clear config 3-49
unit (Optional)Specifiesaunittobereset.