Enterasys SecureStack C2 C2G170-24 - Clear Gvrp; Set Garp Timer

clear gvrp
10-24 802.1Q VLAN Configuration
Mode
Switchcommand,read‐write.
Examples
ThisexampleshowshowtoenableGVRPgloballyonthedevice:
C2(su)->set gvrp enable
ThisexampleshowshowtodisableGVRPgloballyonthedevice:
C2(su)->set gvrp disable
ThisexampleshowshowtoenableGVRPonge.1.3:
C2(su)->set gvrp enable ge.1.3
clear gvrp
UsethiscommandtoclearGVRPstatusorononeormoreports.
Syntax
clear gvrp [port-string]
Parameters
Defaults
Ifport‐stringisnotspecified,GVRPstatuswillbeclearedforallports.
Mode
Switchcommand,read‐write.
Example
ThisexampleshowshowtoclearGVRPstatusgloballyonthedevice:
C2(su)->clear gvrp
set garp timer
Usethiscommandtoadjustthevaluesofthejoin,leave,andleavealltimers.
Syntax
set garp timer {[join timer-value] [leave timer-value] [leaveall timer-value]}
port-string
Parameters
port‐string (Optional)ClearsGVRPstatusonspecificport(s).Foradetaileddes criptionof
possibleport‐stringvalues,referto“PortStringSyntaxUsedintheCLI”on
page 7‐2.
jointimer‐value SetstheGARPjointimerincentiseconds(Referto802.1Qstandard.)
leavetimer‐value SetstheGARPleavetimerincentiseconds(Referto802.1Qstandard.)