Enterasys SecureStack C2 C2G170-24 - Clear Vlan Egress; Set Vlan Egress

set vlan egress
SecureStack C2 Configuration Guide 10-15
set vlan egress
UsethiscommandtoaddportstotheVLANegresslistforthedevice,ortopreventoneormore
portsfromparticipatinginaVLAN.Thisdetermineswhichportswilltransmitframesfora
particularVLAN.
Syntax
set vlan egress vlan-list port-string [untagged | forbidden | tagged]
Parameters
Defaults
Ifuntagged,forbiddenortaggedisnotspecified,theportwillbeaddedtotheVLANegresslist
astagged.
Mode
Switchcommand,read‐write.
Examples
Thisexampleshowshowtoaddge.1.5through10totheegresslistofVLAN7.Thismeansthat
theseportswilltransmitVLAN7framesastagged
:
C2(su)->set vlan egress 7 ge.1.5-10 untagged
Thisexampleshowshowtoforbidports13through15inslot1fromjoiningVLAN7anddisallow
egressonthoseports:
C2(su)->set vlan egress 7 ge.1.13-15 forbidden
Thisexampleshowshowtoallowport2inslot1totransmitVLAN7framesasuntagged:
C2(su)->set vlan egress 7 ge.1.2 untagged
clear vlan egress
UsethiscommandtoremoveportsfromaVLAN’segresslist.
vlan‐list
Specifies the VLAN where a port(s) will be added to the egress list.
port‐string SpecifiesoneormoreportstoaddtotheVLANegresslistofthespecified
vlan‐list.Foradetaileddescriptionofpossibleport‐stringvalues,referto
“PortStringSyntaxUsedintheCLI”onpage 7‐2.
untagged|
forbidden|
tagged
(Optional)Addsthespecifiedportsas:

• untagged—Causestheport(s)totransmitframeswithoutanIEEE
802.1Qheadertag.
• forbidden—Instructsthedevicetoignoredynamicrequests(either
throughGVRPordynamicegress)fromtheport(s)tojointheVLAN
anddisallowsegressonthatport.
• tagged—Causestheport(s)totransmit
802.1Qtaggedframes.
Note: The following command will reset the specified port’s egress status to tagged. To set the
specified ports back to the default egress status of untagged, you must issue the set vlan egress
command as described on page 10-15.