Enterasys SecureStack C2 C2G170-24 User Manual

SecureStack C2 Configuration Guide 20-1
20
IPv4 Routing Protocol Configuration
ThischapterdescribestheIPv4RoutingProtocolConfigurationsetofcommandsandhowtouse
them.
Activating Advanced Routing Features
Inordertoenableadvancedroutingprotocols,suchasOSPF,DVMRP,VRRP,andPIM‐SM,ona
SecureStackC2device,youmustpurchaseandactivatealicensekey.Ifyouhavepurchasedan 
advancedroutinglicense,andhaveenabledroutingonthedevice,youcanactivateyourlicenseas
describedin
thechapterentitled“ActivatingLicensedFeatures.”Ifyouwishtopurchasean
advancedroutinglicense,contactEnterasysNetworksSales.
Configuring RIP
Purpose
Toenableand configuretheRoutingInformationProtocol(RIP).
Router: The commands covered in this chapter can be executed only when the device is in router
mode. For details on how to enable router configuration modes, refer to “Enabling Router
Configuration Modes” on page 18-2.
For information about... Refer to page...
Activating Advanced Routing Features 20-1
Configuring RIP 20-1
Configuring OSPF 20-11
Configuring DVMRP 20-33
Configuring IRDP 20-37
Configuring VRRP 20-42
Configuring PIM-SM 20-49
Note: The command prompts used in examples throughout this guide show a system where the
VLAN 1 interface has been configured for routing. The prompt changes depending on your current
configuration mode, your specific device, and the interface types and numbers configured for
routing on your system.

Enterasys SecureStack C2 C2G170-24 Specifications

General

Brand	Enterasys
Model	SecureStack C2 C2G170-24
Category	Switch
Language	English