Enterasys SecureStack C2 C2G170-24

Configuring Secure Shell (SSH)
SecureStack C2 Configuration Guide 23-73
Configuring Secure Shell (SSH)
Purpose
Toreview,enable,disable,andconfiguretheSecureShell(SSH)protocol,whichprovidessecure
Telnet.
Commands
show ssh status
UsethiscommandtodisplaythecurrentstatusofSSHontheswitch.
Syntax
show ssh status
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐only.
Example
ThisexampleshowshowtodisplaySSHstatusontheswitch:
C2(su)->show ssh status
SSH Server status: Disabled
set ssh
Usethiscommandtoenable,disableorreinitializeSSHserverontheswitch.Bydefault,theSSH
serverisdisabled.
Syntax
set ssh {enable | disable | reinitialize}
For information about... Refer to page...
show ssh status 23-73
set ssh 23-73
set ssh hostkey 23-74