Enterasys SecureStack C2 C2G170-24 User Manual

Using the Command Line Interface
1-6 Introduction
Using the Command Line Interface
Starting a CLI Session
Connecting Using the Console Port
ConnectaterminaltothelocalconsoleportasdescribedinyourSecureStackC2InstallationGuide.
Thestartupscreen,Figure 1‐1,willdisplayontheterminal.YoucannowstarttheCommandLine
Interface(CLI)by
•usingadefaultuseraccount,asdescribedin“UsingaDefaultUserAccount”
onpage 1‐7,or
•usinganadministratively‐assigneduseraccountasdescribedin“UsinganAdministratively
ConfiguredUserAccount”onpage 1‐7.
Figure 1-1 SecureStack C2 Startup Screen
Split horizon Enabled for RIP packets without poison reverse.
Stub area (OSPF) None configured.
Telnet Enabled.
Telnet port (IP) Set to port number 23.
Timers (OSPF) SPF delay set to 5 seconds. SPF holdtime set to 10 seconds.
Transmit delay (OSPF) Set to 1 second.
VRRP Disabled.
Table 1-2 Default Settings for Router Operation (Continued)
Output... What it displays...
Username:admin
Password:
Enterasys SecureStack C2
Command Line Interface
Enterasys Networks, Inc.
50 Minuteman Rd.
Andover, MA 01810-1008 U.S.A.
Phone: +1 978 684 1000
E-mail: support@enterasys.com
WWW: http://www.enterasys.com
(c) Copyright Enterasys Networks, Inc. 2008
Chassis Serial Number: 041800249041
Chassis Firmware Revision: 5.02.xx.xxxx
C2(su)->

Enterasys SecureStack C2 C2G170-24 Specifications

General

Brand	Enterasys
Model	SecureStack C2 C2G170-24
Category	Switch
Language	English