Enterasys SecureStack C2 C2G170-24

show newaddrtrap
SecureStack C2 Configuration Guide 8-29
Commands
show newaddrtrap
Usethiscommandtodisplaytheglobalandport‐specificstatusoftheSNMPnewMACaddresses
trapfunction.
Syntax
show newaddrtrap [port-string]
Parameters
Defaults
Ifport‐stringisnotspecified,thestatusofthenewMACaddressestrapfunctionwillbedisplayed
forallports.
Mode
Switchcommand,read‐only.
Usage
Bydefault,thisfunctionisdisabledgloballyandperport.
Example
ThisexampledisplaysthestatusforGigabitEthernetports1through5inslot1.
C2(ro)->show newaddrtrap ge.1.1-5
New Address Traps Globally disabled
Port Enable State
--------- ------------
For information about... Refer to page...
show newaddrtrap 8-29
set newaddrtrap 8-30
show snmp notify 8-30
set snmp notify 8-31
clear snmp notify 8-32
show snmp notifyfilter 8-33
set snmp notifyfilter 8-34
clear snmp notifyfilter 8-34
show snmp notifyprofile 8-35
set snmp notifyprofile 8-36
clear snmp notifyprofile 8-36
port‐string (Optional)DisplaysthestatusofthenewMACaddressestrapfunction
onspecificports.