Enterasys SecureStack C2 C2G170-24 - Set Console Baud; Downloading a Firmware Image

set console baud
3-30 Basic Configuration
Mode
Switchcommand,read‐only.
Example
Thisexampleshowshowtodisplayallconsolesettings:
C2(su)->show console
Baud Flow Bits StopBits Parity
------ ------- ---- ---------- ------
9600 Disable 8 1 none
set console baud
Usethiscommandtosettheconsoleportbaudrate.
Syntax
set console baud rate
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
Thisexampleshowshowtosettheconsoleportbaudrateto19200:
C2(su)->set console baud 19200
Downloading a Firmware Image
YoucanupgradetheoperationalfirmwareintheSecureStackC2switchwithoutphysically
openingtheswitchorbeinginthesamelocation.Therearetwowaystodownloadfirmwaretothe
switch:
•ViaTFTPdownload.ThisprocedureusesaTFTPserverconnectedtothenetworkand
downloadsthefirmwareusingthe
TFTPprotocol.FordetailsonhowtoperformaTFTP
downloadusingthecopycommand,referto“copy”onpage3‐43.Forinformationonsetting
TFTPtimeoutandretryparameters,referto“settftptimeout”onpage3‐45and“settftp
retry”onpage3‐
46.
•Viatheserial(console)port.Thisprocedureisanout‐of‐bandoperationthatcopiesthe
firmwarethroughtheserialporttotheswi tch.Itshouldbeusedincaseswhenyoucannot
connecttheswitchtoperformthein‐bandcopydownl oadprocedureviaTFTP.Serialconsole
downloadhas
beensuccessfullytestedwiththefollowingapplications:
–HyperTerminalCopyright1999
rate Setstheconsolebaudrate.Validvaluesare:300,600,1200,2400,48 00,5760,
9600,14400,19200,38400,and115200.