Enterasys SecureStack C2 C2G170-24

show spantree stats
SecureStack C2 Configuration Guide 9-5
show spantree stats
UsethiscommandtodisplaySpanningTreeinformationforoneormoreports.
Syntax
show spantree stats [port port-string] [sid sid] [active]
Parameters
Defaults
Ifport‐stringisnotspecified,SpanningTreeinformationforallportswillbedisplayed.
Ifsidisnotspecified,informationforSpanningTree0willbedisplayed.
Ifactiveisnotspecifiedinformationforallportswillbedisplayedregardlessofwhetherornot
theyhavereceivedBPDUs.
Mode
Switchcommand,read‐only.
set spantree protomigration 9-24
show spantree spanguard 9-25
set spantree spanguard 9-25
clear spantree spanguard 9-26
show spantree spanguardtimeout 9-27
set spantree spanguardtimeout 9-27
clear spantree spanguardtimeout 9-28
show spantree spanguardlock 9-28
clear/set spantree spanguardlock 9-29
show spantree spanguardtrapenable 9-29
set spanstree spanguardtrapenable 9-30
clear spanstree spanguardtrapenable 9-30
show spantree legacypathcost 9-31
set spantree legacypathcost 9-31
clear spantree legacypathcost 9-32
For information about... Refer to page...
portport‐string (Optional)Displaysinformationforthespecifiedport(s).Foradetailed
descriptionofpossibleport‐‐stringvalues,referto“PortSt ringSyntaxUsed
intheCLI”onpage 7‐2.
sidsid (Optional)DisplaysinformationforaspecificSpanningTreeidentifier.If
notspecified,SID0isassumed.
active (Optional)Displaysinformation
forportsthathavereceivedSTPBPDUs
sinceboot.