Enterasys SecureStack C2 C2G170-24 - Set Sntp Poll-Timeout; Clear Sntp Poll-Timeout; Set Timezone

set sntp poll-timeout
SecureStack C2 Configuration Guide 14-33
set sntp poll-timeout
Usethiscommandtosetthepolltimeout(inseconds)foraresponsetoaunicastSNTPrequest.
Syntax
set sntp poll-timeout timeout
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
ThisexampleshowshowtosettheSNTPpolltimeoutto10seconds:
C2(su)->set sntp poll-timeout 10
clear sntp poll-timeout
UsethiscommandtocleartheSNTPpolltimeout.
Syntax
clear sntp poll-timeout
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐write.
Example
ThisexampleshowshowtocleartheSNTPpolltimeout:
C2(su)->clear sntp poll-timeout
set timezone
UsethiscommandtoconfigurethecurrenttimezoneasanoffsetfromUTC.
Syntax
set timezone name [hours] [minutes]
timeout Specifiesthepolltimeoutinseconds.Validvaluesare1to30.