Enterasys SecureStack C2 C2G170-24 - Clear Spantree Lplock

clear spantree lplock
9-44 Spanning Tree Configuration
Parameters
Defaults
Ifnoport‐stringisspecified,statusisdisplayedforallports.
IfnoSIDisspecified,SID0isassumed.
Mode
Switchcommand,read‐only.
Example
ThisexampleshowshowtodisplayLoopProtectlockstatusonge.1.1:
C2(rw)->show spantree lplock port ge.1.1
The LoopProtect lock status for port ge.1.1 , SID 0 is UNLOCKED
clear spantree lplock
Usethiscommandtomanuallyunlockablockedportandoptionally,perSID.Thedefaultstateis
unlocked.
Syntax
clear spantree lplock port-string [sid sid]
Parameters
Defaults
IfnoSIDisspecified,SID0isassumed.
Mode
Switchcommand,read‐only.
Example
ThisexampleshowshowtoclearLoopProtectlockfromge.1.1:
C2(rw)->show spantree lplock port ge.1.1
The LoopProtect lock status for port
ge.1.1 , SID 0 is LOCKED
C2(rw)->clear spantree lplock ge.1.1
C2(rw)->show spantree lplock port
ge.1.1
The LoopProtect lock status for port
ge.1.1 , SID 0 is UNLOCKED
port‐string (Optional)Specifiesport(s)forwhichtodisplaytheLoopProtectlock
status.
sidsid (Optional)SpecifiesthespecificSpanningTree(s)forwhichtodisplay
theLoopProtectlockstatus.Validvaluesare0‐4094 .Ifnotspecified,
SID0isassumed.
port‐string Specifiesport(s)forwhichtocleartheLoopProtectlock.
sidsid (Optional)SpecifiesthespecificSpanningTree(s)forwhichtoclearthe
LoopProtectlock.Validvaluesare 0‐4094.Ifnotspecified,SID0is
assumed.