set lldp tx-interval
6-22 Discovery Protocol Configuration
set lldp tx-interval
Usethiscommandtosetthetime,inseconds,betweensuccessiveLLDPframetransmissions
initiatedbychangesintheLLDPlocalsysteminformation.
Syntax
set lldp tx-interval frequency
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
Thisexamplesetsthetransmitintervalto20seconds.
C2(rw)->set lldp tx-interval 20
set lldp hold-multiplier
Usethiscommandtosetthetime‐to‐livevalueusedinLLDPframessentbythisdevice.Thetime‐
to‐liveforLLDPDUdataiscalculatedbymultiplyingthetransmitintervalbytheholdmultiplier
value.
Syntax
set lldp hold-multiplier multiplier-val
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
Thisexamplesetsthetransmitintervalto20secondsandtheholdmultiplierto5,whichwill
configureatime‐to‐liveof100tobeusedintheTTL fieldintheLLDPDUheader.
C2(rw)->set lldp tx-interval 20
C2(rw)->set lldp hold-multiplier 5
frequency SpecifiesthenumberofsecondsbetweentransmissionsofLLDP
frames.Valuecanrangefrom5to32,768seconds.Thedefaultis30
seconds.
multiplier‐val Sp ecifiesthemultipliertoapplytothetransmitintervaltodetermine
thetime‐to‐livevalue.Valuecanrangefrom2to10.Defaultvalueis4.
To Next Page
