Enterasys SecureStack C2 C2G170-24 User Manual

show ip mroute
SecureStack C2 Configuration Guide 20-59
show ip mroute
UsethiscommandtodisplaytheIP multicastroutingtable.
Syntax
show ip mroute
Parameters
None.
Defaults
None.
Mode
Anyroutermode.
Usage
Themulticastroutingtableshowshowamulticastroutingprotocol,suchasPIMandDVMRP,
willforwardamulticastpacket.Informationinthetableincludessourcenetwork/maskand
upstreamneighbors.
ForinformationaboutDVMRP,see“ConfiguringDV MRP”onpage20‐33.
Example
Thisexampleshowstheoutputofthiscommand.
C2(su)->router#show ip mroute
Active IP Multicast Sources
Flags: D - Dense, S - Sparse, C - Connected, L - Local,P - Pruned, R - RP-bit set,
F - Register flag, T - SPT-bit set,Outgoing interface flags: H - Hardware switched
Timers: Uptime/Expires
Interface state: Interface, Next-Hop or VCD, State/Mode
Source Network : 192.168.111.10
Source Mask : 0.0.0.0
MultiCast Group : 239.1.8.9
Uptime : 6336
Upstream Neighbor: 0.0.0.0
Upstream Vlan : 111
Downstream Vlans : 8
Source Network : 192.168.111.10
Source Mask : 0.0.0.0
MultiCast Group : 239.1.7.105
Uptime : 6336
Table 20-13 show ip pimsm staticrp Output Details
Output Field What it displays
Address The IP address of the RP.
Group Address The group address supported by the RP.
Group Mask The group mask for the group address.

Enterasys SecureStack C2 C2G170-24 Specifications

General

Brand	Enterasys
Model	SecureStack C2 C2G170-24
Category	Switch
Language	English