Enterasys SecureStack C2 C2G170-24

Dynamic ARP Inspection Commands
17-20 DHCP Snooping and Dynamic ARP Inspection
Dynamic ARP Inspection Commands
set arpinspection vlan
UsethiscommandtoenabledynamicARPinspectionononeormoreVLANs,andoptionally,
enableloggingofinvalidARPpackets.
Syntax
set arpinspection vlan vlan-range [logging]
Parameters
Defaults
Loggingisdisabledbydefault.
Mode
Switchcommand,read‐write.
Usage
ThiscommandenablesdynamicARPinspection(DAI)ononeormoreVLANs.WhenDAIis
enabledonaVLAN,DAIiseffectivelyenabledontheinterfaces(physicalportsorLAGs)thatare
membersofthatVLAN.
For information about... Refer to page...
set arpinspection vlan 17-20
set arpinspection trust 17-21
set arpinspection validate 17-22
set arpinspection limit 17-22
set arpinspection filter 17-23
show arpinspection access-list 17-24
show arpinspection ports 17-25
show arpinspection vlan 17-25
show arpinspection statistics 17-26
clear arpinspection validate 17-27
clear arpinspection vlan 17-27
clear arpinspection filter 17-29
clear arpinspection limit 17-30
clear arpinspection statistics 17-30
vlan‐range SpecifiestheVLANorrangeofVLANsonwhichtoenabledynamic
ARPinspection.
logging (Optional)EnablesloggingofinvalidARPpacketsforthatVLAN.