Enterasys SecureStack C2 C2G170-24 - Set Logging Server

set logging server
SecureStack C2 Configuration Guide 14-3
set logging server
UsethiscommandtoconfigureaSyslogserver.
Syntax
set logging server index [ ip-addr ip-addr] [facility facility] [severity severity]
[descr descr] [port port] [state {enable | disable}]
Parameters
Defaults
Ifip‐addrisnotspecified,an entryintheSyslogservertablewillbecreatedwiththespecified
indexnumberandamessagewilldisplayindicatingthatnoIPaddresshasbeenassigned.
Ifnotspecified,facility,severityandportwillbesettodefaultsconfiguredwiththesetlogging

defaultcommand(“setloggingdefault”onpage 14‐5).
Ifstateisnotspecified,the serverwillnotbeenabledordisabled.
Mode
Switchcommand,read‐write.
index Specifiestheservertableindexnumberforthisserver.Validvaluesare1‐
8.
ip‐addrip‐addr (Optional)SpecifiestheSyslogmessageserver’sIPaddress.
facilityfacility (Optional)Specifiestheserver’sfacilityname.Validvaluesare:local0to
local7.
severityseverity (Optional)Specifiestheseveritylevelatwhich
theserverwilllog
messages.Validvaluesandcorrespondinglevelsare:
1—emergencies(systemisunusable)
2—alerts(immediateactionrequired)
3—criticalconditions
4—errorconditions
5—warningconditions
6—notifications(significantconditions)
7—informationalmessages
8—debuggingmessages
descrdescr (Optional)Specifiesatextualstring
descriptionofthisfacility/server.
portport (Optional)SpecifiesthedefaultUDPporttheclientusestosendtothe
server.
stateenable|
disable
(Optional)Enablesordisablesthisfacility/serverconfiguration.