Enterasys SecureStack C2 C2G170-24 - Set Spantree Fwddelay

set spantree fwddelay
9-20 Spanning Tree Configuration
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐write.
Example
Thisexampleshowshowtogloballyresetthemaximumagingtime:
C2(su)->clear spantree maxage
set spantree fwddelay
UsethiscommandtosettheSpanningTreeforwarddelay.
Syntax
set spantree fwddelay delay
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Usage
Theforwarddelayisthemaximumtime(inseconds)therootdevicewillwaitbeforechanging
states(i.e.,listeningtolearningtoforwarding).Thisdelayisrequiredbecauseeverydevicemust
receiveinformationabouttopologychangesbeforeitstartstoforwardframes.Inaddition,each
portneedstimetolistenfor
conflictinginformationthatwouldmakeitreturntoablockingstate;
otherwise,temporarydataloopsmightresult.
Example
Thisexampleshowshowtogloballysetthebridgeforwarddelayto16seconds:
C2(su)->set spantree fwddelay 16
delay Specifiesthenumberofsecondsforthebridgeforwarddelay.Validvalues
are4‐30.