Enterasys SecureStack C2 C2G170-24

set ip address
SecureStack C2 Configuration Guide 3-11
set ip address
UsethiscommandtosetthesystemIPaddress,subnetmaskanddefaultgateway.
Syntax
set ip address ip-address [mask ip-mask] [gateway ip-gateway]
Parameters
Defaults
Ifnotspecified,ip‐maskwillbesettothenaturalmaskoftheip‐addressandip‐gatewaywillbesetto
theip‐address.
Mode
Switchcommand,read‐write.
Usage
Parametersmustbeenteredintheordershown(hostIP,thenmask,thengateway)forthe
commandtobeaccepted.
Example
ThisexampleshowshowtosetthesystemIPaddressto10.1.10.1withamaskof255.255.128.0:
C2(su)->set ip address 10.1.10.1 mask 255.255.128.0
clear ip address
UsethiscommandtoclearthesystemIPaddress.
Syntax
clear ip address
Parameters
None.
Defaults
None.
Note: The C2 does not support the ability for a user to configure the host's gateway to be a local
routed interface IP. The host's gateway must exist on a different device in the network if one is
configured.
ip‐address SetstheIPaddressforthesystem.ForSecureStackC2systems,thisisthe
IPaddressofthemanagementswitchasdescribedin“AboutSecureStack
C2SwitchOperationinaStack”onpage2‐1.
maskip‐mask (Optional)Setsthesystem’ssubnetmask.
gatewayip‐gateway (Optional)Setsthe
system’sdefaultgateway(next‐hopdevice).