To Next Page

To Previous Page

set spantree mstmap

9-14 Spanning Tree Configuration

set spantree mstmap

UsethiscommandtomaponeormorefilteringdatabaseIDs(FIDs)toaSID.SinceVLANsare

mappedtoFIDs,thisessentiallymapsoneormoreVLANIDstoaSpanningTree(SID).

Syntax

set spantree mstmap fid [sid sid]

Parameters

Defaults

Ifsidisnotspecified,FID(s)willbemappedtoSpanningTree0.

Mode

Switchcommand,read‐write.

Example

ThisexampleshowshowtomapFID3toSID2:

C2(su)->set spantree mstmap 3 sid 2

clear spantree mstmap

UsethiscommandtomapaFIDbacktoSID0.

Syntax

clear spantree mstmap fid

Parameters

Defaults

Iffidisnotspecified,allSIDtoFIDmappingswillbereset.

Mode

Switchcommand,read‐write.

Example

ThisexampleshowshowtomapFID2backtoSID0:

Note: Since any MST maps that are associated with GVRP-generated VLANs will be removed from

the configuration if GVRP communication is lost, it is recommended that you only create MST maps

on statically-created VLANs.

fid SpecifiesoneormoreFIDstoassigntotheMST.Validvaluesare1‐4093,

andmustcorrespondtoaVLANIDcreatedusingthesetvlancommand.

sidsid (Optional)SpecifiesaMultipleSpanningTreeID.Validvaluesare1‐4094,

andmustcorrespondtoaSIDcreated

usingthesetmsticommand.

fid SpecifiesoneormoreFIDstoresetto0.

Enterasys SecureStack C2 C2G170-24 User Manual

Other manuals for Enterasys SecureStack C2 C2G170-24