Enterasys SecureStack C2 C2G170-24 - Set Dhcp Bootp

set dhcp
16-4 DHCP Server Configuration
set dhcp
UsethiscommandtoenableordisabletheDHCPserverfunctionalityontheSecureStackC2.
Syntax
set dhcp {enable | disable}
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
ThisexampleenablesDHCPserverfunctionality.
C2(rw)->set dhcp enable
set dhcp bootp
UsethiscommandtoenableordisableautomaticaddressallocationforBOOTPclients.By
default,addressallocationforBOOTPclientsisdisabled.RefertoRFC1534,“Interoperation
BetweenDHCPandBOOTP,”formoreinformation.
Syntax
set dhcp bootp {enable | disable}
Parameters
clear dhcp conflict 16-6
set dhcp exclude 16-7
clear dhcp exclude 16-7
set dhcp ping 16-8
clear dhcp ping 16-8
show dhcp binding 16-9
clear dhcp binding 16-9
show dhcp server statistics 16-10
clear dhcp server statistics 16-10
For information about... Refer to page...
enable|disable EnablesordisablesDHCPserverfunctionality.Bydefault,DHCPserveris
disabled.
enable|disable EnablesordisablesaddressallocationforBOOTPclients.