Enterasys SecureStack C2 C2G170-24 User Manual

set dhcp pool dns-server
16-24 DHCP Server Configuration
Mode
Switchcommand,read‐write.
Example
Thisexampleremovesthedefaultrouterfromtheaddresspool“auto1.”
C2(rw)->clear dhcp pool auto1 default-router
set dhcp pool dns-server
UsethiscommandtospecifyoneormoreDNSserversfortheDHCPclientsservedbytheaddress
poolbeingconfigured.Upto8DNSserverscanbeconfigured.
Syntax
set dhcp pool poolname dns-server address [address2 ... address8]
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
ThisexampleassignsaDNSserverat10.14.10.1totheaddresspool“‘auto1.”
C2(rw)->set dhcp pool auto1 dns-server 10.14.10.1
clear dhcp pool dns-server
UsethiscommandtoremovetheDNSserverlistfromtheaddresspoolbeingconfigured.
Syntax
clear dhcp pool poolname dns-server
Parameters
Defaults
None.
poolname Specifiesthenameoftheaddresspool.Poolnamesmaybeupto31
charactersinlength.
address SpecifiestheIPaddressofaDNSserver.
address2...address8 (Optional)Specifies,inorderofpreference,upto7additionalDNS
serveraddresses.
poolname Specifiesthenameoftheaddresspool.Poolnamesmaybeupto31
charactersinlength.

Enterasys SecureStack C2 C2G170-24 Specifications

General

Brand	Enterasys
Model	SecureStack C2 C2G170-24
Category	Switch
Language	English