Enterasys SecureStack C2 C2G170-24

ip ospf enable
20-14 IPv4 Routing Protocol Configuration
Mode
Routerconfiguration:C2(su)‐>router(Config‐router)#
Example
ThisexampleshowshowtoenableRFC1583comp atibility:
C2(su)->router(Config)#router ospf 1
C2(su)->router(Config-router)#1583compatability
ip ospf enable
UsethiscommandtoenableOSPFonaninterface.ThenoformofthiscommanddisablesOSPFon
aninterface.
Syntax
ip ospf enable
no ip ospf enable
Parameters
None.
Defaults
None.
Mode
Interfaceconfiguration:C2(su)‐>router(Config‐if(Vlan1))#
Example
ThisexampleshowshowtoenableOSPFontheVLAN1interface:
C2(su)->router(Config)#interface vlan 1
C2(su)->router(Config-if(Vlan 1))#ip ospf enable
ip ospf areaid
UsethiscommandtoconfigureareaIDsforOSPFinterfaces.IfOSPFisenabledonaninterfaceas
describedin“ipospfenable”onpage20‐14,theOSPFareawilldefaultto0.0.0.0.Thenoformof
thiscommandremovesOSPFroutingfortheinterfaces.
Syntax
ip ospf areaid area-id
no ip ospf areaid
Parameters
Defaults
None.
area‐id Specifiesthearea‐idtobeassociatedwiththeOSPFinterface.Validvalues
aredecimalvaluesorIPaddresses.