Enterasys SecureStack C2 C2G170-24

Assigning Ports to Policy Profiles
SecureStack C2 Configuration Guide 11-15
Assigning Ports to Policy Profiles
Purpose
Toassign andunassignportstopolicyprofiles.
Commands
set policy port
Usethiscommandtoassignportstoapolicyprofile.
Syntax
set policy port port-string profile-index
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
ThisexampleshowshowtoallowGigabitEthernetports5through15inslot1totransmitframes
accordingtopolicyprofile1:
C2(su)->set policy port ge.1.5-15 1
Note: The C2 switch supports up to three user policies per port.
For information about... Refer to page...
set policy port 11-15
clear policy port 11-16
port‐string Specifiestheport(s)toaddtothepolicyprofile.Foradetaileddescription
ofpossibleport‐stringvalues,referto“PortStringSyntaxUsedintheCLI”
onpage 7‐2.
profile‐index SpecifiestheIDofthepolicyprofile(role)towhichtheport(s)willbe
added.Thisvalue
mustmatchtheprofile‐indexvalueassigned usingthe
setpolicyprofilecommand(“setpolicyprofile”onpage 11‐3)inorder
forapolicyprofiletobeactiveonthespecifiedport.